Total
TDS meter - 3
TDS meter designed to measure salinity and temperature of water. It is also used to monitor the water filtration system, check the correct level of the electrical conductivity of drinking water, check nutrient solutions for feeding plants and fish. The Hold function records the measurement result on the display of the device.
Resource - approximately 1,000 hours of active use, after which it is necessary to replace the batteries of the 357A model.
.
Resource - approximately 1,000 hours of active use, after which it is necessary to replace the batteries of the 357A model.
.
100.00 Dhs
Add to compare
TDS Instructions for Use
Remove the protective cap.
Turn on the device.
Lower it into the liquid to the maximum level (5 cm).
Wait for the readings to stabilize (10 seconds), press the HOLD button to save the results.
A flashing signal means that the result needs to be multiplied by 10.
To measure the temperature, press the TEMP button.
After use, shake off any remaining liquid and close the protective cap.
TDS indications
0-50 — water after reverse osmosis
50-100 — clean water
100-300 — tap water
300-500 — water from a reservoir
from 500 — technical water, drinking is prohibited
Remove the protective cap.
Turn on the device.
Lower it into the liquid to the maximum level (5 cm).
Wait for the readings to stabilize (10 seconds), press the HOLD button to save the results.
A flashing signal means that the result needs to be multiplied by 10.
To measure the temperature, press the TEMP button.
After use, shake off any remaining liquid and close the protective cap.
TDS indications
0-50 — water after reverse osmosis
50-100 — clean water
100-300 — tap water
300-500 — water from a reservoir
from 500 — technical water, drinking is prohibited
