Total
ARO XLP11-4040
Extra-low pressure reverse osmosis membrane made of aromatic polyamide. Can operate at extremely low pressure, providing performance and impurity cut-off level up to 99%. Suitable for Aquaphor Professional reverse osmosis systems.
Average performance: 7.6 m3/day
Active membrane area: 8.4 m²
.
Average performance: 7.6 m3/day
Active membrane area: 8.4 m²
.
917.00 Dhs
Add to compare
Extra-low pressure reverse osmosis membrane made of aromatic polyamide. Works at extremely low pressure, providing a performance and impurity rejection rate of up to 99%. Suitable for desalination of surface water with low salt content (NaCl ≤1000ppm), groundwater, tap water and municipal water. Membrane elements used for the second stage of desalination in double-pass reverse osmosis systems. Mainly applied to the production of pure water, boiler water, water for food production and pharmaceuticals. Suitable for Aquaphor Professional reverse osmosis systems.
Technical specification
Working surface of the membrane: 8.4 sq.m
Average productivity: 7.6 m3/day
Stable reduction of salt content: 98.0%
Minimum reduction of salt content: 97.5%
Operating conditions
Working pressure (maximum): 4.14 MPa
Maximum volume of inlet water: 3.6 m3/h
Maximum temperature of inlet water: 45°C
Maximum. SDI15 water supply: 5
Inlet water pH values during the working cycle: 3 - 10
Inlet water pH values during chemical treatment: 2 - 12
Inlet water residual chlorine concentration: < 0.1 mg/l
Maximum pressure drop across one membrane element: 0.1 MPa
Maximum pressure drop across one housing containing 6 membrane elements: 0.34 MPa
Technical specification
Working surface of the membrane: 8.4 sq.m
Average productivity: 7.6 m3/day
Stable reduction of salt content: 98.0%
Minimum reduction of salt content: 97.5%
Operating conditions
Working pressure (maximum): 4.14 MPa
Maximum volume of inlet water: 3.6 m3/h
Maximum temperature of inlet water: 45°C
Maximum. SDI15 water supply: 5
Inlet water pH values during the working cycle: 3 - 10
Inlet water pH values during chemical treatment: 2 - 12
Inlet water residual chlorine concentration: < 0.1 mg/l
Maximum pressure drop across one membrane element: 0.1 MPa
Maximum pressure drop across one housing containing 6 membrane elements: 0.34 MPa
